Carbon Remover PDF Print E-mail
Written by PT. Chemical Mandiri Jaya   
Saturday, 03 October 2009 23:26

BUSOL CARBON REMOVER


INTRODUCTION
BUSOL CARBON REMOVER is a two layer product. The top layer is a floating seal, which prevents escape of solvent vapors, minimizes drogout losses.
The remaining is a compound of highly effective solvents surface-active agents and special agents to remove carbon.

APPLICATION
BUSOL CARBON REMOVER is used undiluted for cleaning motorblocks, gear boxes,  pistons, oil pump, oil filters, sprayer, pipes burners, pipeline, coolers, cleaning of carburettes, injector system components and all other parts where carbonized oil,  gum and fuel residues must be removed.

DIRECTION FOR USE
Simply immerse the parts to be cleaned into suitable container filled with BUSOL CARBON REMOVER. Depending on the nature of contamination cleaning time will be between 2 and 10 hour. Following soaking the parts should be pressure spray rinsed with water.

PROPERTIES AND SAFETY REGULATIONS

  • Contains Methylene Chloride and cresols, BUSOL CARBON REMOVER in  containers has no flashpoint. When it is used in immersion baths, however it becomes a flashpoint of about 80oC.
  • Non-corrosive to metals.
  • BUSOL CARBON REMOVER can be corrosive to plastics and rubber parts. So test first for corrosion.
  • Avoid contact with skin, eyes, and clothing.
  • Take off immediately all contamined clothing.
  • Serious risk of poisoning by inhalation, swallowing or skin contact.
  • Keep away from foodstuff and beverages.
  • Keep container properly closed and in a cool well-ventilated place.



Last Updated on Saturday, 17 October 2009 06:47